| Step
28
Install the rear wheel and tighten the axle nut to 110 N-m (11.0
kgf-m, 79.6 lb-ft). Install a new cotter pin in the axle. Remount
the drive chain with a new masterlink, or reuse the existing masterlink
if bike is so equipped. Route the brake hose and tighten the hose
union bolt, with new washers, to 23 N-m (2.3 kgf-m, 16.5 lb-ft)
with a 12mm socket wrench. Bleed air from the brake system after
installation of the hose. Carefully place the swingarm stand under
the spools and remove the tie downs and jackstands. Reinstall the
tail and lower cowlings. Reinstall the passenger and rider seats.
|
